Enterasys Networks 9034313-07 manual Set lldp port tx-tlv

set lldp port tx-tlv

Defaults

None.

Mode

Switch command, read‐write.

Example

After you configure a location information value, you must also configure the port to send the Location Information TLV with the set lldp port tx‐tlv command. This example configures the ELIN identifier 5551234567 on ports ge.1.1 through ge.1.6 and then configures the ports to send the Location Information TLV.

C3(rw)->set lldp port location-info 5551234567 ge.1.1-6

C3(rw)->set lldp port tx-tlv med-loc ge.1.1-6

set lldp port tx-tlv

Use this command to select the optional LLDP and LLDP‐MED TLVs to be transmitted in LLDPDUs by the specified port or ports. Use the show lldp port local‐info command to display the values of these TLVs for the port.

Syntax

set lldp port tx-tlv {[all] [port-desc][sys-name][sys-desc][sys-cap] [mgmt- addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr][max-frame] [med- cap] [med-pol][med-loc][med-poe]}port-string

Parameters

all	Adds all optional TLVs to transmitted LLDPDUs.
port‐desc	Port Description optional basic LLDP TLV. Value sent is ifDescr object
	defined in RFC 2863.
sys‐name	System Name optional basic LLDP TLV. Value sent is the
	administratively assigned name for the system.
sys‐desc	System Description optional basic LLDP TLV. Value sent is sysDescr
	object defined in RFC 3418.
sys‐cap	System Capabilities optional basic LLDP TLV. For a network
	connectivity device, value sent can be bridge and/or router.
mgmt‐addr	Management Address optional basic LLDP TLV. Value sent is IPv4
	address of host interface.
vlan‐id	Port VLAN ID IEEE 802.1 Extensions TLV. Value sent is port VLAN
	ID (PVID).
stp	Spanning Tree information defined by Protocol Identity IEEE 802.1
	Extensions TLV. If STP is enabled on the port, value sent includes
	version of protocol being used.
lacp	LACP information defined by Protocol Identity IEEE 802.1
	Extensions TLV. If LACP is enabled on the port, value sent includes
	version of protocol being used.

6-28 Discovery Protocol Configuration