Enterasys Networks 9034313-07 Set logging default, Use this command to set logging default values

set logging default

Defaults

None.

Mode

Switch command, read‐only.

Example

This command shows how to display the Syslog server default values. For an explanation of the command output, refer back to Table 14‐1 on page 14‐3.

C3(su)->show logging default

	Facility	Severity	Port
	-----------------------------------------
Defaults:	local4	warning(5)	514

set logging default

Use this command to set logging default values.

Syntax

set logging default {[facility facility] [severity severity] port port]}

Parameters

facility facility	Specifies the default facility name. Valid values are: local0 to local7.
severity severity	Specifies the default logging severity level. Valid values and
	corresponding levels are:
	1	— emergencies (system is unusable)
	2	— alerts (immediate action required)
	3	— critical conditions
	4	— error conditions
	5	— warning conditions
	6	— notifications (significant conditions)
	7	— informational messages
	8	— debugging messages
port port	Specifies the default UDP port the client uses to send to the server.

Defaults

None.

Mode

Switch command, read‐write.

SecureStack C3 Configuration Guide 14-5