Enterasys Networks 9034313-07 manual Set lldp port med-trap, Set lldp port location-info, Elin

set lldp port med-trap

Mode

Switch command, read‐write.

Example

This example enables transmitting LLDP traps on ports ge.1.1 through ge.1.6.

C3(rw)->set lldp port trap enable ge.1.1-6

set lldp port med-trap

Use this command to enable or disable sending an LLDP‐MED notification when a change in the topology has been sensed on the port (that is, a remote endpoint device has been attached or removed from the port).

Syntax

set lldp port med-trap {enable disable} port-string

Parameters

enable	Enables transmitting LLDP‐MED traps on the specified ports.
disable	Disables transmitting LLDP‐MED traps on the specified ports.
port‐string	Specifies the port or range of ports to be affected.

Defaults

None.

Mode

Switch command, read‐write.

Example

This example enables transmitting LLDP‐MED traps on ports ge.1.1 through ge.1.6.

C3(rw)->set lldp port med-trap enable ge.1.1-6

set lldp port location-info

Use this command to configure LLDP‐MED location information on a port or range of ports. Currently, only Emergency Call Services (ECS) Emergency Location Identification Number (ELIN) is supported.

Syntax

set lldp port location-info elin elin-stringport-string

Parameters

elin	Specifies that the ECS ELIN data format is to be used.
elin‐string	Specifies the location identifier. Value can be from 10 to 25 numerical
	characters.
port‐string	Specifies the port or range of ports to be affected.

SecureStack C3 Configuration Guide 6-27