Enterasys Networks 9034313-07 manual Set radius, Server, Show radius Output Details

	set radius
server	(Optional) Displays RADIUS server configuration information.
index all	For use with the server parameter to show server configuration for all
	servers or a specific RADIUS server as defined by an index.

Defaults

If no parameters are specified, all RADIUS configuration information will be displayed.

Mode

Switch command, read‐only.

Example

This example shows how to display RADIUS configuration information:

C3(rw)->show radius	Enabled
RADIUS status:
RADIUS retries:	3
RADIUS timeout:	20 seconds	Auth-Port	Realm-Type
RADIUS Server	IP Address
--------------	----------	---------	-----------------
10	172.16.20.10	1812	management-access

Table 26‐1 provides an explanation of the command output.

Table 26-1 show radius Output Details

Output Field	What It Displays...
RADIUS status	Whether RADIUS is enabled or disabled.
RADIUS retries	Number of retry attempts before the RADIUS server times out. The default value of 3
	can be reset using the set radius command as described in “set radius” on
	page 26-7.
RADIUS timeout	Maximum amount of time (in seconds) to establish contact with the RADIUS server
	before retry attempts begin. The default value of 20 can be reset using the set
	radius command as described in “set radius” on page 26-7.
RADIUS Server	RADIUS server’s index number, IP address, and UDP authentication port.
Realm-Type	Realm defines who has to go through the RADIUS server for authentication.
	• Management-access: This means that anyone trying to access the switch (Telnet,
	SSH, Local Management) has to authenticate through the RADIUS server.
	• Network-access: This means that all the users have to authenticate to a RADIUS
	server before they are allowed access to the network.
	• Any-access: Means that both Management-access and Network-access have
	been enabled.

set radius

Use this command to enable, disable, or configure RADIUS authentication.

Syntax

set radius {enable disable} {retries number-of-retries} {timeout timeout} {server index ip-address port [secret-value] [realm {management-access any network-access}} {realm {management-access any network-access} {indexall}}

SecureStack C3 Configuration Guide 26-7