Enterasys Networks 9034313-07 manual Set cos port-config

set cos port-config

Example

This example shows how to show all CoS settings:

C3(su)->show cos settings			IRL	flood-ctrl
CoS Index Priority		ToS
--------- ---------- ------- -------				----------
0	0	48	*	enabled
1	1	*	*	enabled
2	2	*	*	enabled
3	3	*	*	enabled
4	4	*	*	enabled
5	5	*	*	enabled
6	6	*	*	enabled
7	7	*	*	enabled

set cos port-config

Use this command to create a port group for inbound rate limiting or flood control and add or remove ports from the group.

Syntax

set cos port-config {irlflood-ctrl}group-type-index[name name] [ports port- list] [append] [clear]

Parameters

irl	Specifies that this is an inbound rate limiting (IRL) port group.
flood‐ctrl	Specifies that this is a flood control port group.
group‐type‐index	Specifies an inbound rate limiting port group/type index. Valid entries are
	in the form of group#.port‐type.
	Valid values for group# can range from 0 to 7. Valid values for port‐type
	can range from 0 to 1, although only port type 0 is currently supported.
	For example, port group 3 would be specified as 3.0.
name name	(Optional) User defined name for the group.
ports port‐list	(Optional) Ports assigned to the group. All ports must be of the same port
	type (Fast Ethernet, Gigabit Ethernet).
append	(Optional) Append (add) the ports to the ports that are already in the
	group.
clear	(Optional) Clear the given ports from those assigned to the group.

Defaults

None.

Mode

Switch command, read‐write.

Usage

CoS port groups are identified by group number and the type of ports in the group, in the form of group#.port‐type. The port group 0.0 exists by default. This default port group cannot be removed and all physical ports in the system are assigned to it. Up to seven additional port groups (1

11-24 Policy Classification Configuration