Enterasys Networks 9034313-07 manual Clear garp timer, Leaveall timer‐, Join

		clear garp timer
	leaveall timer‐	Sets the GARP leaveall timer in centiseconds (Refer to 802.1Q standard.)
	value
	port‐string	Specifies the port(s) on which to configure GARP timer settings. For a
		detailed description of possible port‐string values, refer to “Port String
		Syntax Used in the CLI” on page 7‐1.
Defaults
	None.
Mode

Switch command, read‐write.

Usage

The setting of these timers is critical and should only be changed by personnel familiar with the 802.1Q standards documentation, which is not supplied with this device.

Examples

This example shows how to set the GARP join timer value to 100 centiseconds for all ports:

C3(su)->set garp timer join 100 *.*.*

This example shows how to set the leave timer value to 300 centiseconds for all ports:

C3(su)->set garp timer leave 300 *.*.*

This example shows how to set the leaveall timer value to 20000 centiseconds for all ports:

C3(su)->set garp timer leaveall 20000 *.*.*

clear garp timer

Use this command to reset GARP timers back to default values.

Syntax

clear garp timer {[join] [leave] [leaveall]} port-string

Parameters

join	(Optional) Resets the join timer to 20 centiseconds.
leave	(Optional) Resets the leave timer to 60 centiseconds.
leaveall	(Optional) Resets the leaveall time to 1000 centiseconds.
port‐string	Specifies the port or ports on which to reset the GARP timer(s).

Defaults

At least one optional parameter must be entered.

Mode

Switch command, read‐write.

SecureStack C3 Configuration Guide 10-25