6
EN

How To Attach The Core Filter

Attach the Core Filter(s) (if provided with your model 墌 pg. 5) to an optional cable(s). The Core Filter
reduces interference.
Release the
stoppers on both
ends of the Core
Filter.
Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core Filter.
Wind the cable once around the outside of the Core Filter
as shown in the illustration.
•Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
Close the Core Filter until it
clicks shut.
3 cm
Stopper
䡲When connecting cables, attach the end with the Core Filter to the camcorder.
Wind once

Automatic Demonstration takes place when “DEMO

MODE” is set to “ON” (factory-preset).

䡲Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch is set to “ ” or “ ”
and no cassette is in the camcorder.
䡲Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
䡲“DEMO MODE” remains “ON” even if the camcorder power is
turned off.
䡲To cancel Automatic Demonstration:
1.Set the Power Switch to “ ” while pressing down the Lock
Button located on the switch and press the MENU/BRIGHT
wheel in. The Menu Screen appears.
2.Rotate the MENU/BRIGHT wheel to select “ SYSTEM”
and press it. The SYSTEM Menu appears.
3.Rotate the MENU/BRIGHT wheel to select “DEMO MODE”
and press it. The Sub Menu appears.
4.Rotate the MENU/BRIGHT wheel to select “OFF” and press
it.
5.Rotate the MENU/BRIGHT wheel to select “ RETURN”,
and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
AUTOMATIC DEMONSTRATION
MODEDEMO –
ON
OFF
MENU/BRIGHT Wheel
Sub Menu
Lock Button
Power Switch