JVC GR-DVL120 specifications Audio Dubbing, To hear the dubbed sound during playback

EN 43

Display

Audio Dub Standby mode

6e

Speaker

Power Switch

Remote sensor

Stereo microphone

RM-V700U (optional)

A.DUB

PAUSESTOP PLAY

Audio Dubbing

The audio track can be customized only when recorded in the 12-bit mode (
pg. 33).

NOTES:

●Audio Dubbing is not possible on a tape recorded in 16- bit audio, on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Audio Dubbing while watching on the television, make connections (
pg. 20).

1 Play back the tape to locate the point where editing will start, then press PAUSE (6).

2 While holding A.DUB (e) on the remote control, press PAUSE (6). “6e” appears.

3 Press PLAY (4) , then begin “narrating”. Speak into the microphone.

•To pause dubbing, press PAUSE (6).

4 To end Audio Dubbing, press PAUSE (6), then STOP (5).

To hear the dubbed sound during playback . . .

..... set “12BIT MODE” to “SOUND 2” or “MIX” in the

Menu Screen (
pg. 36, 37).

NOTES:

●Sound is not heard from the speaker during Audio Dubbing.

●When editing onto a tape that was recorded at 12-bit, the old and new soundtracks are recorded separately.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-bit to 16-bit in mid-recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit

audio or a blank portion, Audio Dubbing stops (
pg. 62).