Switch Utility Commands, Download | D-Link TM DES-6500 manual

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

SWITCH UTILITY COMMANDS

The switch utility commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.

Command	Parameters
download	[firmware_fromTFTP <ipaddr> <path_filename 64> unit
	[all_line_card cpu <unitid 1-8>]} cfg_fromTFTP <ipaddr>
	<path_filename 64> {increment}

upload	[cfg_toTFTP log_toTFTP] <ipaddr> <path_filename 64>

ping	<ipaddr> {times <value 1-255>} {timeout <sec 1-99>}

traceroute	<ipaddr> {ttl <value 1-60> port <value 30000-64900> timeout
	<sec 1-65535> probe <value <1-9>

enable autoconfig

disable autoconfig

show autoconfig

Each command is listed, in detail, in the following sections.

Purpose	Used to download and install new firmware or a switch
	configuration file from a TFTP server or a CompactFlash memory
	card.
Syntax	[firmware_fromTFTP <ipaddr> <path_filename 64> unit
	[all_line_card cpu <unitid 1-8>]} cfg_fromTFTP <ipaddr>
	<path_filename 64> {increment}
Description	This command is used to download a new firmware or a switch
	configuration file from a TFTP server or a CompactFlash memory
	card.
Parameters	firmware_fromTFTP − Download and install new firmware on the
	Switch from a TFTP server.
	<ipaddr> − The IP address of the TFTP server. The TFTP
	server must be on the same IP subnet as the Switch.
	<path_filename 64> − The DOS path and filename of the
	firmware or switch configuration file on the TFTP server. For
	example, C:\3226S.had.
	unit [all_line_card cpu <unitid 1-8>] − all specifies all
	installed modules except the CPU module, cpu specifies the
	chassis’ CPU module and <unitid> is the unit ID of a specific
	installed module that will receive the download.
	cfg_fromTFTP - Download a switch configuration file from a TFTP
	server.
	<ipaddr> − The IP address of the TFTP server. The TFTP
	server must be on the same IP subnet as the Switch.
	<path_filename 64> − The DOS path and filename of the
	firmware or switch configuration file on the TFTP server or
	CompactFlash card. For example, C:\3226S.had.