D-Link TM DES-6500 manual Config 802.1x authparameter

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config 802.1x auth_parameter

Purpose	Used to configure the 802.1x Authentication parameters on a
	range of ports. The default parameter will return all ports in the
	specified range to their default 802.1x settings.
Syntax	config 802.1x auth_parameter ports [<portlist> all]
	[default {direction [both in] port_control [force_unauth
	auto force_auth] quiet_period <sec 0-65535> tx_period
	<sec 1-65535> supp_timeout <sec 1-65535>
	server_timeout <sec 1-65535> max_req <value 1-10>
	reauth_period <sec 1-65535> enable_reauth [enable
	disable]}]

Description

Parameters

The config 802.1x auth_parameter command is used to configure the 802.1x Authentication parameters on a range of ports. The default parameter will return all ports in the specified range to their default 802.1x settings.

<portlist> − Specifies a range of ports. The port list is specified by listing the lowest slot number and the beginning port number on that slot, separated by a colon. Then the highest slot number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4 specifies all of the ports between slot 1, port 3 and slot 2, port 4 − in numerical order.

all − Specifies all of the ports on the Switch.

default − Returns all of the ports in the specified range to their 802.1x default settings.

direction [both in] − Determines whether a controlled port blocks communication in both the receiving and transmitting directions, or just the receiving direction.

port_control − Configures the administrative control over the authentication process for the range of ports. The user has the following authentication options:

•force_auth − Forces the Authenticator for the port to become authorized. Network access is allowed.

•auto − Allows the port’s status to reflect the outcome of the authentication process.

•force_unauth − Forces the Authenticator for the port to become unauthorized. Network access will be blocked.

quiet_period <sec 0-65535>− Configures the time interval between authentication failure and the start of a new authentication attempt.

tx_period <sec 1-65535>- Configures the time to wait for a response from a supplicant (user) to send EAP Request/Identity packets.

supp_timeout <sec 1-65535>- Configures the time to wait for a response from a supplicant (user) for all EAP packets, except for the Request/Identity packets.

server_timeout <sec 1-65535>- Configure the length of time to wait for a response from a RADIUS server.

max_req <value 1-10>− Configures the number of times to retry

198