D-Link TM DES-6500 manual Config ospf aggregation, Show ospf aggregation areaid

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

DES-6500:4#delete ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary Command: delete ospf aggregation 10.1.1.1 10.48.76..122/16 lsdb_type summary

Success.

DES-6500:4#

config ospf aggregation

Purpose	Used to configure the OSPF area aggregation settings.
Syntax	config ospf aggregation <area_id> <network_address>
	lsdb_type summary {advertise [enabled disabled]}
Description	This command is used to configure the OSPF area aggregation
	settings.
Parameters	<area_id> − A 32-bit number in the form of an IP address
	(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
	OSPF domain.
	<network_address> − The 32-bit number in the form of an IP
	address that uniquely identifies the network that corresponds to
	the OSPF Area.
	lsdb_type summary − Specifies the type of address aggregation.
	advertise [enabled disabled] − Allows for the advertisement
	trigger to be enabled or disabled.
Restrictions	Only administrator-level users can issue this command.

Usage Example

To configure the OSPF area aggregation settings:

DES-6500:4#config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary advertise enable

Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary advertise enable

Success.

DES-6500:4#

show ospf aggregation

Purpose	Used to display the current OSPF area aggregation settings.
Syntax	show ospf aggregation {<area_id>}
Description	This command will display the current OSPF area aggregation
	settings.
Parameters	<area_id> − Enter this parameter to view this table by a specific
	OSPF area ID.
Restrictions	None.

312