D-Link TM DES-6500 manual Show ports, Flowcontrol enabled disabled Enable or disable flow control

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config ports

	from the master. If one connection is set for 1000 master, the
	other side of the connection must be set for 1000 slave. Any other
	configuration will result in a link down status for both ports. None
	denotes the Switch will serve no role for stacking.
	flow_control [enabled disabled] – Enable or disable flow control
	for the specified ports.
	learning [enabled disabled] − Enables or disables the MAC
	address learning on the specified range of ports.
	state [enabled disabled] − Enables or disables the specified
	range of ports.
	description <desc 32> - Enter an alphanumeric string of no more
	than 32 characters to describe a selected port interface.
	clear – Enter this command to clear the port description of the
	selected port(s).
Restrictions	Only administrator-level users can issue this command.

Example usage:

To configure the speed of port 3 of unit 1 to be 10 Mbps, full duplex, learning and state enable:

DES-6500:4#config ports 1:1-1:3 speed 10_full learning enabled state enabled Command: config ports 1:1-1:3 speed 10_full learning enable stated enabled

Success.

DES-6500:4#

show ports

Purpose	Used to display the current configuration of a range of ports.
Syntax	show ports {<portlist>} {description}
Description	This command is used to display the current configuration of a
	range of ports.
Parameters	{<portlist>} − Specifies a range of ports to be displayed. The port
	list is specified by listing the lowest slot number and the beginning
	port number on that slot, separated by a colon. Then the highest
	slot number, and the highest port number of the range (also
	separated by a colon) are specified. The beginning and end of the
	port list range are separated by a dash. For example, 1:3 specifies
	slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
	specifies all of the ports between slot 1, port 3 and slot 2, port 4 −
	in numerical order.
	{description} – Adding this parameter to the command will allow
	the user to view previously configured descriptions set on various
	ports on the Switch.
Restrictions	None.

Example usage:

To display the configuration of all ports on a standalone switch:

26