
xStack
Example usage:
To add the mirroring ports:
Command: config mirror port 1:10 add source ports
Success.
config mirror port delete
Purpose | Used to delete a port mirroring configuration. |
Syntax | config mirror port <port> delete source port <portlist> [rx tx |
| both] |
Description | This command is used to delete a previously entered port |
| mirroring configuration. |
Parameters | port <port> − This specifies the Target port (the port where |
| mirrored packets will be sent). The port is specified by listing the |
| lowest slot number and the beginning port number on that slot, |
| separated by a colon. For example, 1:3 specifies slot number 1, |
| port 3. 2:4 specifies slot number 2, port 4. |
| delete source port – Adding this parameter will delete source ports |
| according to ports entered using the <portlist>. |
| <portlist> − This specifies a range of ports that will be mirrored. |
| That is, the range of ports in which all traffic will be copied and |
| sent to the Target port. The port list is specified by listing the |
| lowest slot number and the beginning port number on that slot, |
| separated by a colon. Then the highest slot number, and the |
| highest port number of the range (also separated by a colon) are |
| specified. The beginning and end of the port list range are |
| separated by a dash. For example, 1:3 specifies slot number 1, |
| port 3. 2:4 specifies slot number 2, port 4. |
| the ports between slot 1, port 3 and slot 2, port 4 − in numerical |
| order. |
| tx − Allows the mirroring of only packets sent to (flowing out of) the |
| port or ports in the port list. |
| both − Mirrors all the packets received or sent by the port or ports |
| in the port list. |
Restrictions | Only |
|
|
Example usage:
To delete the mirroring ports:
Command: config mirror 1:10 delete source port
Success.
115