
xStack
create vlan
information is defined by the Systems Network Architecture (SNA) 802.2 Protocol.
| (SNA) Ethernet II Protocol. |
| |
| to forward packets to this VLAN if the tag in the packet header is |
| concurrent with this protocol. This packet header information is |
| defined by the NetBIOS Protocol. |
| |
| forward packets to this VLAN if the tag in the packet header is |
| concurrent with this protocol. This packet header information is |
| defined by the Xerox Network Systems (XNS) Protocol. |
| |
| forward packets to this VLAN if the tag in the packet header is |
| concurrent with this protocol. This packet header information is |
| defined by the Banyan Virtual Integrated Network Service |
| (VINES) Protocol. |
| |
| forward packets to this VLAN if the tag in the packet header is |
| concurrent with this protocol. This packet header information is |
| defined by the Internet Protocol Version 6 (IPv6) Protocol. |
| |
| Switch to forward packets to this VLAN if the tag in the packet |
| header is concurrent with this protocol defined by the user. This |
| packet header information is defined by entering the following |
| information: |
| <hex |
| accept packets with this hexadecimal 802.1Q Ethernet type |
| value in the packet header. |
| encap [ethernet llc snap all] – Specifies that the Switch will |
| examine the octet of the packet header referring to one of the |
| protocols listed (Ethernet, LLC or SNAP), looking for a match of |
| the hexadecimal value previously entered . all will instruct the |
| Switch to examine the total packet header. After a match is |
| found, the Switch will forward the packet to this VLAN. |
| |
| forward packets to this VLAN if the tag in the packet header is |
| concurrent with this protocol. This packet header information is |
| defined by the Reverse Address Resolution (RARP) Protocol. |
Restrictions | Each VLAN name can be up to 32 characters. If the VLAN is not given |
| a tag, it will be a |
| issue this command. |
120