Chicago Electric 94882 Operating Instructions, Lock Pin Chisel, Important Read before use, Switch

How to attach the chisels

1.Slide the chisels into the Breaker Hammer with the flat cut-out side facing up and while the Rod (4) is aligned with the Chisel shank. See figure 2.

2.The Chisel has a flat space on the shaft that must be turned horizontally when it is inserted. See Figure 2. Pull out on the Pin and rotate it 90° to lock the Chisel in place. The Chisel should be able to move back and forth after it is locked but should not come out.

Lock Pin 4 Figure 2

Chisel

OPERATING INSTRUCTIONS

Important - Read before use

This Breaker Hammer may have decreased performance for a brief period at the begin- ning of each use. This warm-up period lasts approximately 3-5 minutes. This happens because the grease inside the tool may be thick, preventing the tool from operating at full efficiency while the motor is cold. This is normal and does not indicate a problem. To help reduce this effect, store this equipment in temperatures no lower than 50-60° F.

How to turn on the Breaker Hammer

To turn on the Breaker Hammer, flip the Switch (62) shown below in Figure 3.

How to Adjust the impact level of the Breaker Hammer

The Impact level is adjusted by turning the Knob (117). The numbers on the Knob indicate the level of impact. Number one is the lowest level, seven is the highest level. See Figure 4.

Figure 3

Figure 4 Knob (117)

Switch (62)

SKU 94882	REV 12/06
	PAGE 11