D-Link TM DES-6500 manual Create stp instanceid value

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config stp ports

	stations or segments that are capable of being upgraded to
	802.1w RSTP or 802.1s MSTP on all or some portion of the
	segment.
	edge [true false] – true designates the port as an edge port.
	Edge ports cannot create loops, however an edge port can lose
	edge port status if a topology change creates a potential for a
	loop. An edge port normally should not receive BPDU packets. If a
	BPDU packet is received it automatically loses edge port status.
	false indicates that the port does not have edge port status.
	p2p [true false auto] – true indicates a point-to-point (P2P)
	shared link. P2P ports are similar to edge ports however they are
	restricted in that a P2P port must operate in full-duplex. Like edge
	ports, P2P ports transition to a forwarding state rapidly thus
	benefiting from RSTP. A p2p value of false indicates that the port
	cannot have p2p status. auto allows the port to have p2p status
	whenever possible and operate as if the p2p status were true. If
	the port cannot maintain this status (for example if the port is
	forced to half-duplex operation) the p2p status changes to operate
	as if the p2p value were false. The default setting for this
	parameter is auto.
	state [enable disable] − Allows STP to be enabled or disabled for
	the ports specified in the port list. The default is enable.
	lbd [enable disable] - Used to enable or disable the loopback
	detection function on the switch for the ports configured above in
	the config stp command.
Restrictions	Only administrator-level users can issue this command.

Example usage:

To configure STP with path cost 19, hellotime set to 5 seconds, migration enable, and state enable for ports 1-5 of module 1.

DES-6500:4#config stp ports 1:1-1:5 externalCost 19 hellotime 5 migrate yes state enable

Command: config stp ports 1:1-1:5 externalCost 19 hellotime 5 migrate yes state enable

Success.

DES-6500:4#

create stp instance_id

Purpose	Used to create a STP instance ID for MSTP.
Syntax	create stp instance_id <value 1-15>
Description	This command allows the user to create a STP instance ID for the
	Multiple Spanning Tree Protocol. There are 16 STP instances on
	the Switch (one internal CIST, unchangeable) and the user may
	create up to 15 instance IDs for the Switch.
Parameters	<value 1-15> - Enter a value between 1 and 15 to identify the
	Spanning Tree instance on the Switch.
Restrictions	Only administrator-level users can issue this command.

80