empty
tt foil+cu
replace
6 | e |
40 | replac |
20 |
|
... |
|
0 |
|
8975 | reset |
|
80 | efoil+cutt |
100 | replace |
40 | |
60 |
|
20 |
|
... |
|
0 |
|
Description
1Foil protection cap
2Shaver foil
3Cutter block
4Release buttons
5Long hair trimmer
6Switch
7Charging lights (green)
8Low charge light (red)
9Replacement light for shaving parts
10Reset button
11Pilot light
12Shaver socket
13Special cord set
Charging the shaver
•When charging for the first time: Using the special cord set, connect the shaver to an electrical outlet.
The shaver must be switched off. Charge it for at least 4 hours (special cord set and shaver might get warm). Once the shaver is completely charged, shave until fully discharged. Then recharge to full capacity again (1 hour).
•A full charge will give up to 50 minutes of cordless shaving time, depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.
•Best environmental temperature range for charging is from 60 °F to 95 °F / 15 °C to 35 °C.
•When fully discharged, you may also shave with the shaver connected to an electrical outlet via the special cord set.
Indicator lights
Pilot light (11): The shaver is connected to an electrical outlet.
Model 8975: When the shaver is fully charged, all five charging lights (7) will light up (20% per light), provided the shaver is connected to an electrical outlet or switched on.
6
