![](/images/new-backgrounds/1120111/120111335x1.webp)
SERVICE LOG ERROR MESSAGES | APPENDIX B |
Table B-3. GPIB-Related Error Messages (5 of 8)
Error Message | Description |
|
|
Bad filename | The supplied filename was bad. The filename can have 8 characters maximum. No |
| extensions. The filename must start with and alpha type character (A thru Z). After |
| that the allowable characters are alpha, numeric (0 thru 9) and underscore (_). |
|
|
Conflict with rotary knob | You should not be using the rotary knob and the GPIB at the same time. |
|
|
Too many data points for exter- | A 6700B series external source can handle 501 data points. |
nal source | A 68000 series external source can handle 999 data points. |
|
|
Recalled setup corrupted | These are problems with the recalled setup. |
Hardware mismatch in recalled |
|
setup |
|
Software mismatch in recalled |
|
setup |
|
|
|
Too many data points for Dis- | The maximum number of data points in discrete fill is 1601. |
crete Fill |
|
|
|
Not enough data points for Dis- | The minimum number or data points in discrete fill is 2. |
crete Fill |
|
|
|
Discrete Fill end frequency out of | The number of points for discrete fill puts the end frequency out of range. |
range |
|
|
|
Step is too large | When setting up a time domain harmonic sweep, cannot get 2 data points because |
| the start frequency is too high for the approximate stop frequency. In a group delay |
| display, the delay aperture percent of sweep is less than one step size. |
|
|
Range too small | An attempt was made to set a distance or time span value too small. This can also be |
| done via inappropriate values for start and stop. |
|
|
Start or stop out of range | An attempt was made to set a distance or time start or stop value out of range. This |
| can also be done via inappropriate values for center and span. |
|
|
No bands defined | An attempt was made to turn on multiple source mode with no band definitions. |
|
|
Out of frequencies for new band | The current set of multiple source mode bands use up all the frequency range of the |
definition | 373XXA. Therefore, no more bands can be defined. |
Source out of range by equation |
|
External source out of range by |
|
equation |
|
|
|
File is read only | An attempt was made to write to a write protected file. |
|
|
File not found | An attempt was made to access a |
|
|
Floppy drive not ready | An attempt was made to access the floppy drive with no floppy disk installed. |
|
|
Floppy disk full | An attempt was made to write to a floppy disk or the hard disk when no space was left |
Hard disk full | on the disk. |
|
|
373XXA MM |