Anritsu 373XXA manual Gpib Query Error Descriptions

APPENDIX B SERVICE LOG ERROR MESSAGES

Table B-3.GPIB-Related Error Messages (6 of 8)

Error Message	Description
Floppy disk write protected	An attempt was made to write to a write protected floppy disk.
Recalled setup or data file cor-	An attempt to recall a setup from internal memory, the GPIB or disk failed due to soft-
rupt	ware revision or hardware mismatch or checksum error.
New frequency list not allowed in	Cannot set up a new discrete fill definition while performing a calibration or when cor-
current state	rection is turned on. Also, cannot do this when group delay is the graph type on the
	active channel.
State change not permitted	An attempt was made to perform an illegal state change or action based on the cur-
	rent instrument state. This includes attempting to store (1) an undefined band defini-
	tion, (2) certain changes from the calibration state, or (3) the cal define state when
	defining discrete frequencies.
Faulty label or file name	The label or file name associated with the current mnemonic is faulty.
Illegal characters in filename	The first character in a filename must be an alpha type. The remaining characters can
	be alpha, numeric, or underscores. An extension is not permitted.
Filename too long	The maximum ledngth for filenames is 8 characters. An extension is not permitted.
Floppy disk read error	Read or write error(s) occurred while attempting to access the indicated disk.
Floppy disk write error
Hard disk read error
Hard disk write error
Floppy disk not found	Other error messages which suggest that the indicated drive is in need of service.
Hard disk not found
General disk buffer error
General floppy drive failure
Floppy disk init failure
General hard disk failure
Hard disk control failure
Hard disk init failure
Unknown disk error

	7205 GPIB QUERY ERROR DESCRIPTIONS
No Response data available	Generated if the controller attempts to read response data from the 373XXA and none
	is available.
No Response data after PM	This is the same as the ‘no response data available’ case above except that a pro-
completion	gram message was currently being parsed and executed when the controller at-
	tempted to read data. Detection of this error was deferred until the parser/execution
	block was finished with the current program message and it was observed that no re-
	sponse data was generated.

373XXA MM B-13