Anritsu 373XXA manual Table B-3.GPIB-Related Error Messages 3

SERVICE LOG ERROR MESSAGES APPENDIX B

Table B-3.GPIB-Related Error Messages (3 of 8)

Error Message	Description
Invalid cal term for calibration	An attempt was made to program a calibration term which does not exist for the cur-
type	rent calibration type.
Front panel setup not valid	An attempt was made to get a front panel setup that did not contain a correct/valid
	state.
Normalization data not valid	An attempt was made to reference normalization data when there was no normaliza-
	tion data currently stored.
Command sequence too long	An attempt was made to define a device trigger command sequence which had more
	than 255 characters.
Unable to display menu	An attempt was made to display a menu which could not be displayed for the current
	373XXA state.
String too long	An attempt was made to enter a string for the following mnemonics which exceeded
	the specified maximum length.
	LTD, LID, LMS and LNM - maximum length is 15 characters.
	LOC - maximum length is 79 characters.
Must specify a calibration type	In order to perform a calibration, the calibration type must be specified by the use of
first	one of the Cxx mnemonics (i.e. C12, C8T, etc.) PRIOR to the issuance of the mne-
	monics CWC, TDC or BEG.
Parameter value unchanged	An attempt was made to change a start/stop frequency or number of data points to a
	value outside of the current calibrated range with correction turned on.
Parameter change not permitted	An attempt was made to perform an illegal state change or action based on the cur-
	rent 373XXA state. This includes attempting to store an undefined band definition. Or
	certain changes from the calibration state or the calibration define state when defining
	discrete frequencies.
Parameter value out of range	An attempt was made to set a parameter to a value outside of the permissible range
Parameter out of hardware	of values for the parameter.
range
Standard cal method not valid	In a waveguide type of calibration, the standard (OSL) cal method is forbidden.
for waveguide
Out of calibrated range	An attempt was made to change a parameter not permitted to be changed with correc-
	tion on.
Start must be must be less than	An attempt was made to set a new start frequency, distance or time greater than or
stop	equal to the current stop frequency, distance or time. Or to set a new stop frequency,
	distance or time less than or equal to the current start frequency, distance or time.
Tune mode requires a 12 term	Perform a 12 term calibration prior to turning on tune mode.
calibration

B-10 373XXA MM