D-Link TM DES-6500 manual Config systemseverity trap log all critical warning, Information

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config system_severity

Purpose	To configure when and where severity messages are to be
	recorded.
Syntax	config system_severity [trap log all] [critical warning
	information]
Description	This command is used to configure the system severity levels on the
	Switch. When an event occurs on the Switch, a message will be sent
	to the SNMP agent (trap), the Switch’s log or both. Events occurring
	on the Switch are separated into three main categories.
	• Information – Events classified as information are basic events
	occurring on the Switch that are not deemed as problematic,
	such as enabling or disabling various functions on the Switch.
	• Warning - Events classified as warning are problematic events
	that are not critical to the overall function of the Switch but do
	require attention, such as unsuccessful downloads or uploads
	and failed logins.
	• Critical – Events classified as critical are fatal exceptions
	occurring on the Switch, such as hardware failures or spoofing
	attacks.
Parameters	Choose one of the following to identify where severity messages are
	to be sent.
	• trap – Entering this parameter will define which events
	occurring on the Switch will be sent to a SNMP agent for
	analysis.
	• log – Entering this parameter will define which events
	occurring on the Switch will be sent to the Switch’s log for
	analysis.
	• all – Entering this parameter will define which events occurring
	on the Switch will be sent to a SNMP agent and the Switch’s
	log for analysis.
	Choose one of the following to identify what type of severity
	warnings are to be sent to the destination entered above.
	• critical – Entering this parameter along with the proper
	destination, stated above, will instruct the Switch to send only
	critical events to the Switch’s log or SNMP agent.
	• warning – Entering this parameter along with the proper
	destination, stated above, will instruct the Switch to send
	critical and warning events to the Switch’s log or SNMP agent.
	• information – Entering this parameter along with the proper
	destination, stated above, will instruct the switch to send
	informational, warning and critical events to the Switch’s log or
	SNMP agent.
Restrictions	Only administrator-level users can issue this command.

Example usage:

To configure the system severity:

73