D-Link TM DES-6500 manual Delete route redistribute, Ospf

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config route redistribute dst rip src

Parameters	src {all internal external type_1 type_2 inter+e1 inter+e2} −
	Allows the selection of the protocol of the source device. The user
	may choose between:
	• all – Specifies both internal an external.
	• internal – Specifies the internal protocol of the source device.
	• external - Specifies the external protocol of the source
	device.
	• type_1 - Calculates the metric (for RIP to OSPF) by adding
	the destination’s interface cost to the metric entered in the
	Metric field.
	• type_2 - Uses the metric entered in the Metric field without
	change. This field applies only when the destination field is
	OSPF.
	• inter+e1 – Specifies the internal protocol AND type 1 of the
	external protocol.
	• inter+e2 – Specifies the internal protocol AND type 2 of the
	external protocol.
	metric <value 0-16>− Allows the entry of an OSPF interface cost.
	This is analogous to a Hop Count in the RIP routing protocol.
Restrictions	Only administrator-level users can issue this command.

Example Usage:

To configure route redistributions:

DES-6500:4#config route redistribute dst ospf src rip mettype type_1 metric 2

Command: config route redistribute dst ospf src rip mettype type_1 metric 2

	Success.
	DES-6500:4#
delete route redistribute
Purpose		Used to delete an existing route redistribute configuration on the
		Switch.
Syntax		delete route redistribute {dst [rip ospf] src [rip static local
		ospf]}
Description		This command will delete the route redistribution settings on this
		switch.
Parameters		dst [rip ospf] − Allows the selection of the protocol on the
		destination device. The user may choose between RIP and OSPF.
		src [rip static local ospf] − Allows the selection of the protocol
		on the source device. The user may choose between RIP, static,
		local or OSPF.
Restrictions		Only administrator-level users can issue this command.

275