D-Link TM DES-6500 Config accessprofile profileid ipv6, Ipv6addr port port permit priority value

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual

config access_profile profile_id (ipv6)

Purpose	Used to configure the IPv6 access profile on the Switch and to
	define specific values for the rules that will be used to by the Switch
	to determine if a given packet should be forwarded or filtered. Masks
	entered using the create access_profile command will be
	combined, using a logical AND operational method, with the values
	the Switch finds in the specified frame header fields.
Syntax	config access_profile profile_id <value 1-8> [add access_id
	<value 1-65535>] ipv6 {class <value 0-255> flowlabel <hex 0x0-
	0xfffff> source_ipv6 <ipv6addr> destionation_ipv6
	<ipv6addr>} port <port> [permit {priority <value 0-7>
	{replace_priority}} deny] delete <value 1-65535>]
Description	This command is used to define the rules used by the Switch to
	either filter or forward packets based on the IPv6 part of each packet
	header.
Parameters	profile_id <value 1-8>- Enter an integer between 1 and 8 that is
	used to identify the access profile that will be configured with this
	command. This value is assigned to the access profile when it is
	created with the create access_profile command. The lower the
	profile ID, the higher the priority the rule will be given.
	add access_id <value 1-65535>- Adds an additional rule to the
	above specified access profile. The value specifies the relative
	priority of the additional rule. Up to 65535 different rules may be
	configured for the IPv6 access profile.
	ipv6 - Specifies that the Switch will look into the IPv6 fields in each
	packet, with emphasis on one or more of the following fields:
	• class <value 0-255>- Entering this parameter will instruct the
	Switch to examine the class field of the IPv6 header. This class
	field is a part of the packet header that is similar to the Type of
	Service (ToS) or Precedence bits field in IPv4.
	• flowlabel <hex 0x0-fffff>- Entering this parameter will instruct
	the Switch to examine the flow label field of the IPv6 header.
	This flow label field is used by a source to label sequences of
	packets such as non-default quality of service or real time
	service packets. This field is to be defined by the user in hex
	form.
	• source_ipv6 <ipv6addr> - Specifies an IP address mask for the
	source IPv6 address.
	• destination_ipv6 <ipv6addr> - Specifies an IP address mask
	for the destination IPv6 address.
	port <portlist> - The access profile for Ethernet may be defined for
	each port on the Switch. The port list is specified by listing the lowest
	switch number and the beginning port number on that switch,
	separated by a colon. Then the highest switch number, and the
	highest port number of the range (also separated by a colon) are
	specified. The beginning and end of the port list range are separated
	by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
	specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
	between switch 1, port 3 and switch 2, port 4 − in numerical order.
	permit – Specifies that packets that match the access profile are
	permitted to be forwarded by the Switch.
	• priority <value 0-7>− This parameter is specified to re-write
	the 802.1p default priority previously set in the Switch, which is

224