!Clamp
POWERHEAD
END
30 inches
|
| I ATTACHMENT | ||
Lower | Shoulde | • | END | |
Strap | Clamp | o | ||
| ||||
|
| |||
3.Insert two screws into the screw holes.
4.Secure shoulder strap clamp by tightening screws with the hex wrench.
5.Insert your right arm and head through the shoulder strap and al- low it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the
right side of your waist.
NOTE: A
shoulder strap to allow the strap to rest flat on the shoulder.
6.Adjust the strap, allowing the book to be about 6 inches below the waist.
7.Fasten the strap hook to the clamp
and lift the tool to the operating position.
8.Try on shoulder strap and adjust for fit and balance before starting the engine or beginning a cutting operation.
NOTE: It may be necessary to relo- cate the shoulder strap clamp on the shaft for proper balancing of unit.
HARNESS
ADJUSTMENT
FOR BALANCE
6 inches | 4 - 12 | |
below | ||
waist | inches | |
above | ||
| ||
| ground |
CONFIGURING YOUR UNIT
You can configure your unit using a trim- mer head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1/2 inch in diameter. To assemble your unit, go to the section for
the desired configuration and follow the instructions.
ASSEMBLY INFORMATION - TRIMMER HEAD
TRIMMER
HEAD
NOTE: Remove the blade and metal shield before attaching the plastic shield and trimmer head. To remove blade, align hole in the dust cup with the hole in the side of the gearbox by rotating the blade. Insert a small screwdriver into aligned holes. This will keep the shaft from turning while loosening the blade nut. Remove blade nut by turning clockwise. Remove the screwdriver. Remove both washers and blade. To remove metal shield, loosen and re-
move the four mounting screws. See AT- TACHING THE METALSHIELD and INSTALLATIONOF THE METAL BLADE for
illustrations. Be sure to store all parts and instructions for future use.
INSTALLATION OF THE TRIMMER
HEAD
NOTE: Before installing the trimmer head, make sure the dust cup and re- taining washer are positioned on the shaft of the gearbox, The retaining washer must be positioned with the raised section toward the gearbox,
