3Com 10014299 manual Start FTP Server, Enter the following commands in system view

		Configure FTP 53
Table 29 Set the authentication mode of FTP server
	Operation	Command
	Start AAA server	aaa-enable
	Disable AAA server	undo aaa-enable
	Turn on the accounting selection switch	aaa accounting-scheme optional
	Turn off the accounting selection switch	undo aaa accounting-scheme
		optional
	Set local authentication for PPP connection	aaa authentication-scheme login
		default local

2Add FTP authorized user name and password Input the following command in system view.

Table 30 Add FTP authorized user name and password

Operation	Command
Add FTP authorized user name and	Local-user username service-type ftp
password	password {simple cipher } password
Delete FTP user	undo user username

For a detailed introduction to the above command, please refer to the chapter “AAA and RADIUS Configuration” in the Security section of this manual.

Start FTP Server

The FTP server can be started after configuring the authentication and authorization of the FTP server. The FTP server supports multi-user access simultaneously. The remote FTP user sends a request to the FTP server, which will execute a corresponding action and return the execution result to the user.

Enter the following commands in system view.

Table 31 Start FTP server

Operation	Command
Start FTP server	ftp-server enable
Disable FTP server	undo ftp-server

Configure Parameters of FTP Service

Configure FTP service parameters according to system running status, so as to make proper use of system resources.

1Set the file name on FTP server

Before the file is uploaded or downloaded, the name of the program/configuration file should be set on the router.

Please enter the following commands in system view.

Table 32 Set the file name on FTP server

Operation	Command
Set the program file name on FTP server	ftp-server system-name file-name
Set the configuration file name on FTP server	ftp-server config-name file-name