264CHAPTER 17: CONFIGURING FRAME RELAY

Configure the parameters of Frame Relay class

1Enable the Frame Relay traffic shaping

Perform the following configurations in synchronous serial interface view.

Table 301 Enable/Disable the Frame Relay traffic shaping

Operation

Command

 

 

Enable the Frame Relay traffic shaping

fr traffic-shaping

 

 

Disable the Frame Relay traffic shaping

undo fr traffic-shaping

 

 

By default, the Frame Relay traffic shaping is not enabled on the interface.

The function of Frame Relay traffic shaping is applied on the outgoing interfaces on a router. Usually it is applied at the DTE end on a Frame Relay network.

2Create a Frame Relay class

Refer to the previous section “Configure Frame Relay class” for the configuration procedure in detail.

3Associate the Frame Relay class with the Frame Relay interface or a PVC

Refer to the previous section “Configure Frame Relay class” for the configuration procedure in detail.

4Configure the Frame Relay class parameters for Frame Relay traffic shaping Perform the following configurations in frame relay class view.

Table 302 Configure the parameters of Frame Relay class

Operation

Command

 

 

Set the CBS of a Frame Relay PVC

cbs [ outbound ] burst-size

 

 

Restore the CBS of a Frame Relay PVC to the

undo cbs [ outbound ]

default value

 

 

 

Set the EBS of a Frame Relay PVC

ebs [ outbound ]

 

excess-burst-size

 

 

Restore the EBS of a Frame Relay PVC to the

undo ebs [ outbound ]

default value

 

 

 

Set the CIR ALLOW of a Frame Relay PVC

cir allow [ outbound ]

 

rate-limit

 

 

Restore the CIR ALLOW of a Frame Relay PVC to

undo cir allow [ outbound ]

the default value

 

 

 

Set the CIR of a Frame Relay PVC

cir rate-limit

 

 

Restore the CIR of a Frame Relay PVC to the

undo cir

default value

 

 

 

Enable the adaptive adjustment function of

traffic-shaping adaptation becn

traffic shaping

[ percentage ]

 

 

Disable the adaptive adjustment function of

undo traffic-shaping adaptation

traffic shaping

becn

 

 

Set the reserved band width of Frame Relay PVC

reserved-bandwidth

 

bandwidth-percentage

 

 

Restore the reserved band width of a Frame

undo reserved-bandwidth

Relay PVC to the default value

 

 

 

The commands cbs, ebs, and cir allow can be used to set the inbound and outbound parameters. However, only the outbound parameters are effective for the Frame Relay traffic shaping.

Page 268
Image 268
3Com 10014299 manual Enable/Disable the Frame Relay traffic shaping, Configure the parameters of Frame Relay class