3Com 10014299 manual Enter Ctrl+B and the system prompts, Network Interface Parameters

40CHAPTER 3: SYSTEM MANAGEMENT

NETWORK INTERFACE PARAMETERS:

Do you want a LAN interface? [N] y

This board's LAN IP address? [169.254.1.1] 10.110.10.1

Subnet mask for LAN (0 for none)? [255.255.0.0]

TFTP SERVER PARAMETERS:

IP address of the TFTP server? [169.254.75.166] 10.110.10.13

What is the name of the file to be loaded and started? [m8240ram.arj]

How long (in seconds) should CPU delay before starting up? [5]

The IP address of the TFTP server? [169.254.75.166] must be set to the IP address of the PC connected to the Ethernet port of the router. After the last parameter is set the following prompts will appear to ask for confirmation:

-------------------------------------------------------------------

NETWORK INTERFACE PARAMETERS:

IP address on LAN is 10.110.10.1

LAN interface's subnet mask is 0xffff0000

HARDWARE PARAMETERS:

Processor type is MPC8240

Internal Clock Rate 250 Mhz

External Clock Rate 100 Mhz

LAN Controller is DEC 21143

Serial channels will use a baud rate of 9600

TFTP SERVER PARAMETERS:

IP address of the TFTP host is 10.110.10.13

The file to download and start is m8240ram.arj

After board is reset, start-up code will wait 5 seconds

-------------------------------------------------------------------

(M)odify any of the 3Com router configuration or (C)ontinue? [M]

2Enter C to confirm the selection and the router performs POST again, and the Boot ROM starts normally.

3The router performs POST, and the following displays:

3Com Router start booting

******************************************

*	*
* 3Com Router Series Boot rom, V4.32	*
*	*

******************************************

3Com Corporation Copyright(C) Reserved.

Compiled at 17:47:11 , Mar 21 2002.

Now testing memory...OK!

256M bytes SDRAM

8192k bytes flash memory Press Ctrl-B to enter Boot Menu

Press Ctrl+B as prompted and the system enters the 3Com Router main software upgrade menu.

The system enters the 3Com Router main software upgrade menu unless you press Ctrl+B within three seconds of displaying “Press Ctrl-B to enter Boot Menu...” on the screen. Otherwise, the system will start decompressing the program. Reboot the router if you want to enter the 3Com Router main software upgrade menu after program decompression is started.

4Enter Ctrl+B and the system prompts:

Please input Bootrom password: