186CHAPTER 14: CONFIGURING SLIP

By default, the synchronous/asynchronous serial interface operates in synchronous mode

2Configure the link layer protocol of the interface to SLIP Perform the following task in the asynchronous interface view.

Table 218 Configure the link layer protocol of the interface to SLIP

Operation

Command

 

 

Configure the link layer protocol of the interface to SLIP

link-protocol slip

 

 

By default, the link layer protocol of the interface is PPP.

Note the following:

The link layer protocol of the interface can be set to SLIP only when it operates in the asynchronous mode.

When link layer protocol LAPB, X.25, HDLC or Frame Relay is operating on the interface, the physical attributes of the interface cannot be modified to asynchronous mode. At this time, you should first modify the link layer protocol of the interface to PPP and then you may change the interface attribute to asynchronous mode.

Display and Debug

Perform the following task in all views to monitor the current state of SLIP in real

SLIP

time.

 

 

Table 219 Enable/Disable the information debugging of SLIP

 

 

 

 

 

 

Operation

Command

 

 

 

 

 

 

Enable the information debugging of SLIP packet

debugging slip { hexadecimal

 

 

 

packet all }

 

 

 

 

Typical SLIP

I. Networking Requirement

 

 

Configuration

Interconnect two Router routers via PSTN and run IP.

 

Example

 

 

 

 

 

II. Networking Diagram

 

 

 

Figure 3-1Networking diagram of SLIP dialer

 

 

Router A

10.110.0.1

 

 

8810003

 

 

 

 

PSTN

 

 

 

8810026

 

 

 

10.110.0.2

Router B

Page 190
Image 190
3Com 10014299 manual Typical Slip, Time, Interconnect two Router routers via Pstn and run IP, Networking Requirement