3Com 10014299 manual Connection, Configuration, Environment, Router, Local/Remote Telnet

Establish Configuration Environment 17

Figure 8 Establish a dial-up connection via “HyperTerminal”

Figure 9 Dial on remote computer

4If a dial-up connection is established, then press Enter after the self-test to display the prompt “Username:” and “password:”. Enter the correct username and the password, then enter the system view of Router.

5Enter command to configure the router or view running status of the router. Enter ? to get help when necessary. For details of specific commands, please refer to the following chapters.

Local/Remote Telnet	After the router powers on, and IP addresses of the interfaces have been properly
Connection	configured on the router, you can use the Telnet client program to establish a
Configuration	connection with the router and log in the router via LAN or WAN. Then configure
Environment	the router.

1As shown in the following two figures, connect the Ethernet port adapter on the computer with the Ethernet interface of the router. To establish a remote