268 CHAPTER 17: CONFIGURING FRAME RELAY

Set the queue type of a Frame Relay PVC to CQ

cq cql list-number

 

 

Restore the queue type of a Frame Relay PVC to

undo cq cql

FIFO

 

 

 

Set the queue type of a Frame Relay PVC to

wfq [

WFQ

congestive-discard-threshold [

 

dynamic-queues ] ]

 

 

Restore the queue type of a Frame Relay PVC to

undo wfq

FIFO

 

 

 

By default, the queue type of a Frame Relay PVC is FIFO.

When the congestion management is enabled on Frame Relay PVCs, the queue type on the interface can only be FIFO.

For the configuration of PQ, CQ and WFQ, refer to the part of QoS.

2Configure Frame Relay Interface Queueing

The user can configure four queueing types on a Frame Relay interface:.FIFO, PQ, CQ and WFQ. All of them are the queues owned by a general QoS. For their configurations, refer to the part of QoS.

Frame Relay interface also supports PVC interface priority queueing (PIPQ). This queueing type can only be applied on a Frame Relay interface. After Frame Relay traffic shaping or Frame Relay congestion management is enabled on a Frame Relay interface, the queueing type on the interface can only be either FIFO or PIPQ.

A PIPQ queue classifies the packets into four categories according to different Frame Relay PVCs.

A PIPQ queue has four sub-queues. They are respectively high-priority queue (top), medium-priority queue (middle), normal-priority queue (normal) and low-priority queue (bottom). The priorities are listed in descending order. The packets will be transmitted according to the priority sequence. Specifically, all the packets in the top queue will be first transmitted, then the packets in the middle queue followed by the packets in the normal queue, and finally those in the bottom queue. Each Frame Relay PVC on the interface has its own PIPQ priority. Therefore, the packets from this PVC can only enter the corresponding PIPQ queue.

Perform the following configurations respectively in interface view and frame relay class view.

Table 310 Configure PIPQ

Operation

Command

 

 

Set the queueing type of Frame Relay interface to

fr pvc-pq [ top-limit

PIPQ and set the length of each PIPQ queue at

middle-limit normal-limit

the same time (in interface view)

bottom-limit ]

 

 

 

Restore the queueing type of Frame Relay

undo fr pvc-pq

interface to FIFO (in interface view)

 

 

 

Set the priority of PIPQ on the Frame Relay PVC

pvc-pq { top middle normal

(in frame relay class view)

bottom }

 

 

Restore the priority of PIPQ on the Frame Relay

undo pvc-pq

PVC to normal (in frame relay class view)

 

 

 

By default, the queueing type of a Frame Relay interface is FIFO.

Page 272
Image 272
3Com 10014299 manual Configure Pipq