3Com 10014299 manual Enter view of specified asynchronous interface, Interface async number

118CHAPTER 10: CONFIGURING WAN INTERFACE

■Set the asynchronous serial interface to work in dialup or dedicated line mode

■Set link layer protocol

■Set baud rate

■Set link establishment mode

■Set the check mode in flow mode

■Set stop bit in flow mode

■Set data bit in flow mode

■Set flow control mode

■Enable or disable level detection

■Enable or disable internal loopback and external loopback

■Set MTU

■Setting the coding format of Modem

The asynchronous serial interface may also need to be configured with SLIP parameter, PPP parameter, BDR parameter, IP address, firewall and standby center parameter as required.

1Set the synchronous/asynchronous serial interface to work in asynchronous mode

If the physical interface to be configured is synchronous/asynchronous serial interface, it must be set to work in asynchronous mode by executing the following commands.

Please use the following command in the view of synchronous / asynchronous serial interface

Table 94 Set the synchronous/asynchronous serial interface to work in asynchronous mode

Operation	Command
Set the synchronous/asynchronous serial interface to	physical-mode async
work in asynchronous mode.

The synchronous/asynchronous serial interface works in synchronous mode by default.

2Enter the view of specified asynchronous serial interface

Please use the following commands to enter the view of the specified serial interface in all views.

Table 95 Enter view of specified asynchronous interface

Operation	Command
Enter the view of specified asynchronous serial interface	interface async number
Enter the view of the specified synchronous/asynchronous	interface serial number
serial interface (which has been set to work in
asynchronous mode)

3Set the asynchronous serial interface to work in dialup or dedicated line mode.

For special asynchronous serial interface or the asynchronous serial interface set from synchronous/asynchronous serial interface, it is possible to dialup with modem command. Please see Operation Manual - Dial-upfor other settings and detailed