3Com 10014299 manual Configure the CQ queue, Configure Router B Configure the access control list

694CHAPTER 49: CONGESTION MANAGEMENT

Figure 222 Networking diagram of CQ typical configuration

PC1:10.1.3.10		PC2:10.1.5.10
	(10.1.1.1) tunnel0 (10.1.1.2)		e0:10.1.5.1
e0.0:10.1.3.1	s0:192.168.0.2
e0.1:10.1.4.1	s0:192.168.0.1	Router	e1:10.1.6.1
Router	(10.1.7.1) tunnel1 (10.1.7.2)

PC3:10.1.4.10 PC4:10.1.6.10

1Configure Router A

[RouterA]acl 105

[RouterA-acl-105]rule normal permit ip source 10.1.4.0 0.0.0.255 destination 10.1.5.0 0.0.0.255

[RouterA-acl-105]rule normal deny ip source any destination any

[RouterA-acl-105]acl 107

[RouterA-acl-107]rule normal permit ip source 192.168.0.2 0.0.0.0 destination 192.168.0.1 0.0.0.0

[RouterA-acl-108]rule normal permit ip source 192.168.1.2 0.0.0.0 destination 192.168.1.1 0.0.0.0

a Configure the CQ queue

[RouterA] qos cql 1 queue 1 queue-length 100

[RouterA] qos cql 1 queue 1 serving 5000

[RouterA] qos cql 1 queue 2 queue-length 100

[RouterA] qos cql 1 queue 2 serving 1000

[RouterA] qos cql 1 protocol ip acl 107 queue 1

[RouterA] qos cql 1 protocol ip acl 108 queue 2 b Configure Serial0 master/slave addresses

[RouterA-Serial0]ip address 192.168.0.1 255.255.255.252

[RouterA-Serial0]ip address 192.168.1.1 255.255.255.252 sub c Apply the CQ queue 1 to Serial0

[RouterA-Serial0] qos cq cql d Configure Tunnel0

[RouterA-Tunnel0]ip address 10.1.1.1 255.255.255.0

[RouterA-Tunnel0] source 192.168.0.1

[RouterA-Tunnel0]destination 192.168.0.2 e Configure Tunnel1

[RouterA-Tunnel1]ip address 10.1.7.1 255.255.255.0

[RouterA-Tunnel1] source 192.168.1.1

[RouterA-Tunnel1]destination 192.168.1.2

2Configure Router B

a Configure the access control list

[RouterB]acl 105