3Com 10014299 manual Helps, Full help, Partial help

Command Line Interface (CLI) 23

View name	Function	Prompt	Enter command	Exit command
X.25 hunt	Configures the X.25	[Router-X25-huntgroup-abc]	Enter x25	Enter quit to return
group view	hunt group parameters		hunt-group abc	to the system view
			round-robin in
			system view
Frame Relay	Configures the FR class	[Router-fr-class-abc]	Enter fr class	Enter quit to return
class view	parameters		abc in system view	to the system view
DLCI view	Configures the DLCI	[Router-fr-dlci-100]	Enter fr dlci 100	Enter quit to return
	parameters		in synchronous serial	to the synchronous
			interface view. (The	serial interface view
			link layer protocol
			encapsulated on the
			interface should be
			FR.
Frame Relay	Configures the FR	[Router-fr-switch-abc]	Enter fr switch	Enter quit to return
switch view	switch parameters		abc in system view	to the system view
MFR interface	Configures the MFR	[Router-MFR0]	Enter interface	Enter quit to return
view	interface parameters		mfr 0 in any views	to the system view
L2TP group	Configures L2TP group	[Router-l2tp1]	Enter l2tp-group	Enter quit to return
view			1 in system view	to the system view
IPSec proposal	Configures a security	[Router-ipsec-proposal-abc]	Enter ipsec	Enter quit to return
view	proposal		proposal abc in	to the system view
			system view
IPSec policy	Configures a security	[Router-ipsec-policy-abc-0]	Enter ipsec	Enter quit to return
view	policy		policy abc 0 in	to the system view
			system view
IKE proposal	Configures an IKE	[Router-ike-proposal-0]	Enter ike	Enter quit to return
view	proposal		proposal 0 in	to the system view
			system view
ACL view	Configures ACL rules	[Router-acl-1]	Enter acl 1 in	Enter quit to return
			system view	to the system view
DHCP address	Configures a DHCP	[Router-dhcpabc]	Enter dhcp server	Enter quit to return
pool view	address pool		ip-pool abc in	to the system view
			system view

The command line prompt character consists of the network device name (Router by default) and the command view name, such as [Router-rip].

The commands are divided according to view. In general, in a certain view, only the commands defined by the view can be executed, but some widely used commands (including ping, display, debugging, reset, save, interface, logic-channel, and controller) can be executed in all views

For some views listed in the above table, you must enable the corresponding functions before you can enter the views. To enter some other views, however, you should configure the related restriction conditions. For more information, see the related chapters in this manual.

In all views, you can use the quit command to return to the superior-level views, and the return command to the system view directly.

Command Line	The command line interface of the 3Com Router provides the following online
Online Help	helps:
	■	Full help
	■	Partial help