3Com 10014299 manual DCC peeraddr matching error

748 CHAPTER 51: CONFIGURING DCC

Message	Fault
DCC: peeraddr matching error	The debugging information is probably outputted
on interface ***, shutdown link	because the local dialer route does not contain the
	remote network address. To solve the problem, add
	the dialer route corresponding to the remote
	network address on the local router or use the dial
	number after removing all the dialer routes
	configured on the local router.
DCC: idle-timeout on interface	The debugging information does not indicate any
*** , shutdown! start	error. DCC normally disconnects the connection,
enable-time	because the local DCC idle-timeout timer has been
	timed out.
DCC: wait-for-carrier-timeout	The debugging information is probably outputted
on a link on interface ***,	because the local router cannot contact the remote
shutdown!start enable-time	end for a long time. It may occur because the
	remote end is busy or the quality of the phone line
	is bad.
DCC: The interface has no	The debugging information is probably outputted
dialer-group, discard the	because the dialer-groupcommand has not been
packet!	configured on the corresponding dialer interface or
	the physical interface on which DCC is directly
	enabled. To solve the problem, refer to the previous
	example to make the configuration.
DCC: there is not a dialer	The debugging information is probably outputted,
number on the interface,	because neither dialer route nor the dialer
failed, discard packet	number is configured on the corresponding dialer
	interface or the physical interface on which DCC is
	enabled directly. To solve the problem, configure
	the dialer route and the dialer number on the local
	end for the outbound call at the local end.
DCC: Enable-timeout is	Rather than indicating an error, the outputted
effective , failed	debugging information means that the
	enable-timeout timer on the corresponding physical
	interface have not timed out yet. The physical
	interface can be used for dialing upon the timeout
	of the timer.