3Com 10014299 manual Configure POS access interface FCM2, Configure POS access interface FCM0

102CHAPTER 7: POS TERMINAL ACCESS SERVICE

9Configure POS access interface FCM2

[Router] interface fcm2

[Router-FCM2]async mode pos 3

Configuration Example when the Router is Located at the FEP Side in

Asynchronous Connection Mode

I. Networking Requirements

Three POS terminals access the Router A located at the FEP side through the FCM and connect to UNIX A (10.1.1.1) and UNIX B (11.1.1.1) in asynchronous connection mode.

II. Networking Diagram

Figure 43 Networking diagram when the router is located at the FEP side in asynchronous connection mode

POS				10.1.1.1/24
terminal			11.1.1.1/24	UNIX A
	PSTN	FCM	A0
POS
				UNIX B
			A1
terminal		Router
POS			11.1.1.2/24
terminal				11.1.1.1/24

III.Configuration Procedure 1 Start the POS access server.

[Router] pos-server enable

2Configure the POS application to UNIX A in asynchronous connection mode, the connected interface is async 0, the application sequence number is 0.

[Router] pos-server app flow 0 async 0

3Configure the POS application to UNIX B in asynchronous connection mode, the connected interface is async 1, the application sequence number is 1.

[Router] pos-server app flow 1 async 1

4Configure the POS multi-application mapping table (to map the packet whose destination address is 01f1 to application 0).

[Router] pos-server map 01f1 0

5Configure the POS multi-application mapping table (to map the packet whose destination address is 01f2 to application 1).

[Router] pos-server map 01f2 1

6Configure POS access interface FCM0.

[Router] interface fcm0

[Router-FCM0]async mode pos 1

7Configure POS access interface FCM1.

[Router] interface fcm1

[Router-FCM1]async mode pos 2

8Configure POS access interface FCM2.

[Router] interface fcm2