3Com 10014299 manual Configure IPX, Modify length of service information reserve queue

Configure IPX 373

clients can always obtain the latest server addresses. The following diagram describes the relation between main components of SAP.

Figure 136 Schematic diagram of the relation between main components of SAP

S e r v e r

I n f o r m a t i o n

T a b l e

						S e r v e r I n f o r m a t i o n
T i m e r								T i m e r
		S A P	P r o c e s s
P e r i o d i c								A g i n g
B r o a d c a s t
							P r o c e s s
P r o c e s s
	S o c k e t				S A P R e q u e s t / R e s p o n s e P a c k e t s
	0 x 4 5 2
				I P X
		N I C s a n d D r i v e r s

Configure IPX	IPX configuration includes:
	■	Activate/deactivate IPX
	■	Enable IPX interface
	■ Adjust Novell IPX delay value
	■ Configure relative parameters of IPX RIP
	■ Configure relative parameters of IPX SAP
	■ Modify length of service information reserve queue
	■	Use trigger refresh
	■	Deactivate horizontal division
	■ Configure IPX packet management
	■ Modify encapsulation format of IPX frame
	■ Configure IPX on WAN
1	Activate/Deactivate IPX
	Perform the following task in system view.
	Table 406 Activate/deactivate IPX
		Operation	Command
		Activate IPX	ipx enable [ node node ]
		Deactivate IPX	undo ipx enable
	If the node of a router is not specified, then the router will use the MAC address of
	its first Ethernet interface as its node address.
2	Enable IPX Interface
	After activating the IPX function of a router, each independent interface must be
	assigned with a network ID so that IPX can run on the interface.