3Com 10014299 manual Load Sharing view, Please perform the following configuration in all views

650CHAPTER 45: CONFIGURING A STANDBY CENTER

priority; after the logic channel changes to up, it's required to switch from the standby interface with the second highest priority to this logic channel.

Perform the following commands in the view of the logic channel.

Table 701 Set the State-judging Conditions When the Main Interface is a Logic Channel

Operation	Command
Set the condition for judging the logic channel as	standby state-down times
down: the logical channel is regarded as down after
the specified number of unsuccessful calls.
seconds is set to make regular inspections so as to	standby state-up seconds
check whether the original logic channel has
recovered its “up” state.

By default, time is set to 0 and seconds is set to 1 second.

Configuring Standby Conduct the following configuration under the interface view or logic channel

Load Sharing view.

Table 702 Configure Interface or Logic Channel Load Sharing

Operation	Command
Configure the standby load sharing of	standby threshold enable-threshold
interface or logic channel	disable-threshold
Disable the standby load sharing	undo standby threshold
configuration of interface and logic	enable-threshold disable-threshold
channel

By default, the standby load sharing function of interface is not enabled.

Displaying and	Please perform the following configuration in all views.
Debugging the	Table 703 Display and Debug Standby Center
Standby Center
	Operation	Command
	Turn on the standby center debugging	debugging standby { event packet }
Standby Center	This section describes several different configurations for standby centers with a
Configuration	suggested procedure for each configuration
Examples

Standby Between Take interface Serial 2 as the standby interface for interface Serial 1.

Interfaces

1Enter the view of Serial 1.

[Router]interface serial 1

2Set Serial 2 as its standby interface.

[Router-Serial1]standby interface serial 2

3Set the time for switchover between main and standby interfaces as 10 seconds.

[Router-Serial1]standby timer enable-delay 10

[Router-Serial1]standby timer disable-delay 10