214CHAPTER 16: CONFIGURING LAPB AND X.25

Figure 64 X.25 switching networking diagram

Quidway Router

X.25 host

PC

X.25 host

PC

1Enable or disable X.25 switching

In the system view, perform the following task to enable or disable X.25 switching.

Table 257 Enable or disable X.25 switching

Operation

Command

 

 

 

Enable X.25 switching

x25 switching

 

 

 

Disable X.25 switching

undo x25

switching

 

 

 

Add or delete a PVC route

Table 258 Add or delete a PVC route

Operation

Command

 

 

Add a PVC route

x25 switch pvc number interface

 

serial port-number pvc number

 

 

Delete a PVC route

undo x25 switch pvc number

 

 

After configuration, the display x25 switch-vc-table pvc command can be used to show the virtual circuit route table.

2Add/Delete an SVC route

In the system view, the commands in the following table can be used to add or delete an SVC route.

Table 259 Add or delete an SVC route

Operation

Command

 

 

Add an SVC route

x25 switch svc x.121-address[ sub-dest

 

destination-address ] [ sub-sourcesource-address

 

] interface serial interface-number

 

 

Delete an SVC route

undo x25 switch svc x.121-address[ sub-dest

 

destination-address ] [ sub-sourcesource-address

 

] [ interface serial interface-number]

 

 

Configure X.25 Load Balancing

After the configuration, use display x25 switch-vc-table svc command to display the switching route table.

Introduction to X.25 Load Balancing

Using the property of hunt group of X.25 protocol, ISPs can provide load balancing function in X.25 packet switching networks. X.25 load balancing can implement the load balancing in different DTEs or different links of a single DTE,

Page 218
Image 218
3Com 10014299 manual Add or delete a PVC route, Introduction to X.25 Load Balancing, Configure X.25 Load Balancing