3Com 10014299 manual Start /Close X.25 switching function, Create/Delete X.25 hunt group

Configure X.25 217

DCE equipment in X.25 networks to provide the function of load balancing for DTE equipment) then configuration of X.25 load balancing needs to be made on the routers.

The main configuration tasks of X.25 load balancing are as follows:

■Start X.25 switching

■Create X.25 hunt group

■Add interfaces and XOT Tunnels to hunt group

■Configure the X.25 switching route whose forward address is hunt group

■Configure other X.25 switching routes

Hunt group addresses do not need separate configuration. Only the destination addresses need to be set as hunt group addresses on source DTEs.

1Start X.25 switching

Perform the following configuration in system view.

Table 260 Start /Close X.25 switching function

Operation	Command
Start X.25 switching	x25 switching
Close X. 25 switching	undo x25 switching

2Create X.25 hunt group

Perform the following configuration in system view.

Table 261 Create/Delete X.25 hunt group

Operation	Command
Create X.25 hunt group	x25 hunt-group hunt-group-name{
	round-robin vc-number }
Delete X.25 hunt group	undo x25 hunt-group hunt-group-name

3Add interfaces and XOT Tunnels to hunt group

Perform the following configuration in X.25 hunt group view.

Table 262 Add/Delete interfaces or XOT Tunnels in hunt group

Operation	Command
Add interfaces to hunt group	channel interface interface-type
	interface-number
Delete specified interfaces from hunt	undo channel interface
group	interface-type interface-number
Add XOT Tunnels to hunt group	channel xot ip-address
Delete specified XOT Tunnels from hunt	undo channel xot ip-address
group

It should be noted that a hunt group can have ten synchronous serial interfaces or XOT Tunnels at most. XOT Tunnels cannot be added to the hunt group that adopts vc-number channel selection policy.

4Configure X.25 switching route which is forwarded to hunt group Perform the following configuration in system view.