Hitachi RAS-SX10HAK / RAC-SX10HAK Prepare The Remote Controller, Install the batteries, Address

PREPARE THE REMOTE CONTROLLER

ENGLISH

1	Install the batteries.
	• Use two AAA-size batteries.

Push mark and pull.

CAUTION

1.Do not mix new and old batteries, or different type of batteries together.

2.Remove the batteries when you do not use the remote controller for 2 or 3 months.

2	Open the cover and press the RESET
	button with a sharp tip item.

RESET

• 18:88 lights up on the current time display and “AM” and “PM” start blinking.

3 Set the current time (Ex: set to 1:30 p.m.)

Press the (TIMER) button to adjust to the current time.

•You can fast forward the time by continuously pressing the

1 button.

Time is incremented

Time is decremented

Press (SET TIME) button to set the current time.

• “AM” or “PM” is lit instead of

2 blinking. It automatically goes off in 10 seconds.

Confirm the current time

• Press the (SET TIME) button to check the current time (The time display disappears 3 minutes later). If necessary, readjust the time following the above procedure 1 and 2.

ABOUT ADDRESS SELECTOR SWITCH

•Address selector switch is used to prevent remote controller signal interference in such circumstance where 2 indoor units are used in the same room. This switch is not usually used. (The factory setting is at “A” side.)

For this setting, please make an inquiry to your sales agent.

Address

Address

Address selector switch

Switch lever

Remote controller	Do not operate by yourself.
backside

– 11 –