Hitachi RAS-SX13HAK / RAC-SX13HAK instruction manual PREPARE THE REMOTE CONTROLLER continued

PREPARE THE REMOTE CONTROLLER (continued)

4	Ampere setting (Standard/Save) can be selected.
	If you experience frequent circuit breaker tripping, set ampere to “Save” to avoid this problem.
	(Ampere is set to “Standard” at the time of purchase.)
		1	Press the	(FUNCTION SELECTOR)
			button until	(SAVE) blinks.

2

RELEASE

While (SAVE) is blinking, point the remote controller towards

the unit and press the (ON/OFF) button.

•A short beep sounds and (SAVE) indicator turns on.

Press the (FUNCTION SELECTOR) button again until (SAVE) blinks.

While (SAVE) is blinking, point the remote controller towards

the unit and press the (ON/OFF) button.

•A short beep sounds and (SAVE) indicator turns off, indicates the setting is released.

Notes for “save” setting

•If ampere is set to “Save”, the maximum heating capacity slightly lowers and starting up of heating operation will take a little longer. Besides, the preset temperature may not be reached if outside temperature is low.

WHEN OPERATING THE REMOTE CONTROLLER

•Point the remote controller to the signal receiver of the unit Signal reception distance is approximately 7m in front of the unit. However, this distance may be shorter or the signal may not be receivable if there is an electronic lighting device in the same room.

•Handle the remote controller with care

Dropping it or getting it wet may compromise its signal transmission capability. After new batteries are inserted into the remote controller, the unit require approximately 10 seconds before it can respond to commands and begin operation.

Approximately 7m from the front

– 12 –