3Com 10014299 manual Create DLSw remote end peer entity, Configure Bridge set connecting to DLSw

Configuration of DLSw 385

Please perform the following configurations in system view.

Table 429 Create DLSw remote end peer entity

Operation	Command
Create DLSw remote end peer entity	dlsw remote ip-address[ backup
	backup-peer-address ] [ priority
	priority-value ] [ max-frame
	max-frame-size ] [max-queue
	max-queue-length ] [ linger minutes ]
	[ compatible { 3com nonstandard } ]
Delete DLSw remote end peer entity	undo dlsw remote ip-address

No DLSw remote end peer entity is created by default.

When creating remote backup-peer, note:

When the remote backup peer is created, the tcp ip-addressshould be the IP address of peer backup entity and the backup backup-peer-addressshould be the IP address of the remote master peer, which has established TCP connection. That is, the user should ensure that TCP connection has been established between the local peer and the remote peer before creating a remote backup peer. When a remote peer is created for the first time, meanwhile, the remote backup peer is also being created, the system will prompt the following information: Primary

peer ip address does not exist

This prompt indicates that the user should create a remote master peer before creating the backup peer.

If the TCP connection of the master link fails, the backup link can be used to maintain the connection (the backup TCP connection link can be found via the display dlsw remote command) until its linger minutes timeout.

3Configure Bridge set Connecting to DLSw

DLSw technology is developed on the basis of bridge technology. Bridge set is a unit for forwarding by bridge. Several Ethernet ports can be configured into a Bridge set in order to forward messages among them. To forward the messages of the specified Bridge set to the remote end over TCP connection, you need to use this command to connect a local Bridge set to DLSw. In another words, the messages of the local Bridge set can be forwarded to the remote end through TCP channel. You can use the command several times to connect several Bridge sets to DLSw, so that all of them can be forwarded through TCP channel.

Please process the following configurations in the system view.

Table 430 Configure Bridge set connecting to DLSw

Operation	Command
Configure Bridge set connecting to DLSw	dlsw	bridge-set
	Bridge-set-number
Delete Bridge set connecting to DLSw	undo	dlsw bridge-set
	Bridge-set-number

No Bridge set connecting to DLSw is configured by default.

4Configure to Add Ethernet Port to Bridge Set

LLC2 message on an Ethernet port can be forwarded to the remote end peer entity through the corresponding TCP channel after the Ethernet port is added to the Bridge set.