3Com 10014299 manual Display and Debug, Set the Response Time to the Invite Clear Message

X.25 PAD Remote Access Service 71

Display and Debug X.25

PAD

Exit command can also be nested with the Pad command. That is, users can access a third or even more routers from a router by repeatedly using the telnet/pad command or by repeatedly using the exit command to exit the routers being accessed in turns until returning to the one from which the first call is placed.

Please implement the following configuration under the system view at the Server side.

Set the Response Time to the Invite Clear Message

If for some unknown reason (for example, the Client side gives an exit request or needs to release link resources) after the Server side of the X.25 PAD sends the link-clearing message Invite Clear to the Client side, the Server side will wait for a response from the Client side. If the Client side fails to respond to the message within the specified time, the Server side will clear the link positively.

Please implement the following configuration under the system view at the Server side.

Table 54 Set the response time to the Invite Clear message

Operation	Command
Set the response time to the Invite Clear message	x29 inviteclear-time time
	seconds

Perform the following configuration in all views.

Table 55 Display and debug X.25 PAD

Operation	Command
Display the relevant information of X.25 PAD	display x25 pad [
	pad-number ] [ tty ]
Enable the debugging of X.25 PAD on varied levels	debugging pad { packet
	error all }

Typical X.25 PAD Configuration Example

I. Networking Requirement

As shown in the figure below, with Serial 0 as the interface to the X.25 network, router A is connected with router B through the X.25 network. It is required that router B can access and configure router A after it calls router A.

II. Networking Diagram

As shown in Figure 33 “Access remote router through an X.25 PAD”.

III. Configuration Procedure

1Configure RouterA:

a Configure X.25 PAD remote users.

[RouterA]local-user paduser service-type exec-guest password simple

pad

bEnable AAA authentication of X.25 PAD remote users.

[RouterA] login pad