3Com 10014299 manual Define a link-set, Share load by source MAC address, Link-set origin

	Configure Bridge’s Routing Function 305
Table 340 Configure bridge set to route or bridge the network layer protocol
Operation		Command
Enable the bridge set to route the network layer		bridge bridge-setrouting { ip
protocol		ipx }
Disable the bridge set to route the network layer		undo bridge bridge-setrouting
protocol		{ ip ipx }
Enable the bridge set to bridge the network layer		bridge bridge-setbridging { ip
protocol		ipx }
Disable the bridge set to bridge the network layer		undo bridge bridge-setbridging
protocol		{ ip ipx }

By default, the bridging is enabled, the routing is disabled.

You can execute the display bridge bridge-setbridge-template command to view the configuration of routing and bridging on each interface.

9Configure Link-Set a Define a link-set

The link set can bundle multiple parallel links between two bridges, thus sharing loads among multiple links and enhancing link bandwidth utilization ratio when there is no bridge loop.

Perform the following configuration in interface view.

Table 341 Define a link-set

Operation	Command
Assign a port to a link-set.	bridge-set bridge-setlink-set
	link-set

bShare load by source MAC address

Perform the following configuration in system view.

Table 342 Share load by source MAC address

Operation	Command
Bind the ports to a link-set to share the load	bridgebridge-set link-setlink-set
by source MAC address	origin
Disable the load sharing by source address	undo bridge bridge-setlink-set
	link-set origin

By default, the load is shared by packets instead of source MAC address. However, the load will be shared by source MAC address, if it is configured.

Executing the display bridge bridge-setlink-setcommand can display the configuration of the link-set on each bridge as well as whether it is sharing the load.

10Configure Bridging over Frame Relay

When establishing a bridge, mapping between the bridge address and DLCI address should be specified.

Perform the following configuration in interface view.