3Com 10014299 manual Configure MFR, Configure a MFR bundle interface MFR interface, Subnumber

Configure Frame Relay 255

will not take effect. On the MFR interface, you can configure the network layer parameters (e.g., IP address) and Frame Relay parameters (e.g., DLCI). The physical interface bundled on the MFR interface will use the parameters on the MFR interface.

Configure MFR

The configuration tasks of the MFR are listed as follows:

■Configure a MFR Bundle

■Configure a MFR Bundle Link

1Configure a MFR bundle

Please perform the following configuration in system view.

Table 291 Configure a MFR bundle interface (MFR interface)

Operation	Command
Configure or enter a MFR bundle interface	interface mfr number [
	.subnumber ] [ multipoint
	point-to-point ]
Remove a MFR bundle interface	undo interface mfr number [
	.subnumber ]

By default, no MFR bundle interface is configured.

Please perform the following configuration in MFR interface view.

Table 292 Configure MFR interface parameter

Operation	Command
configure bundle identification	mfr	bundle-name name
Restore the default bundle identification	undo mfr bundle-name
Set the maximum number of the fragments	mfr	window-size number
allowed by the MFR interface.

The default bundle identification s “mfr” plus the bundle number, for example, “mfr1.

By default, the maximum number of the fragments allowed by the MFR interface is the same with the number of the physical interfaces bundled to it.

By default, the voice packets are sent on the multiple physical interfaces bundled to the MFR interface by turns.

2Configure a MFR bundle link

Please perform the following configuration in synchronous serial interface view.

Table 293 Configure physical interface's link layer protocol to Multilink Frame Relay

Operation	Command
Configure physical interface's link layer protocol to	link-protocol fr mfr number [
Multilink Frame Relay and associate the link with a	name ]
bundle.

By default, no MFR bundle link is created. To remove the association between the physical interface and the MFR interface, configure the interface's link layer protocol to a none MFR type using the link-protocolcommand.

Please perform the following configuration in synchronous serial interface view.