3Com 10014299 manual IP Count Configuration, Enable/Disable IP Count service, Ip count enable

366CHAPTER 23: CONFIGURING IP COUNT

Figure 134 Networking for an IP Count application

169.254.10.1
PC1	E1	PC3
E0:	Router
169.254.10.1

PC2

PC4

A B

IP Count mainly implements the following functions:

■Configure IP Count list

■Make statistics on the output and input packets

■Make statistics on the packets processed by the firewall

■Display all packet statistics

■Clear all packet statistics

IP Count Configuration

Basic Configuration includes:

■Enable IP Count Service

■Enable IP Count on an interface

Advanced Configuration includes:

■Configure IP Count list

■Configure upper threshold for accounting entries in Interior-List

■Configure upper threshold for accounting entries in Exterior-List

■Configure timeout time of IP Count statistics list entries

1Enable IP Count Service

This command can be used to enable or disable IP Count service. You can configure IP Count to make statistics on the packets that the router has input or output depending on the specific requirements on the router.

Perform the following configuration in system view.

Table 399 Enable/Disable IP Count service

Operation	Command
Enable IP Count	ip count enable
Disable IP Count	undo ip count enable

By default, IP Count is not enabled.

2Configure IP Count on an Interface