726CHAPTER 51: CONFIGURING DCC

Secondary rule: The best match is the one that is found first.

Confirm which dialer call-inat server end is associated with the incoming call

In circular DCC, upon receiving an incoming call, the server searches for the dialer call-inmatching the incoming number in the dialer call-incommands configured on the physical interface or the dialer interface to which the physical interfaces belongs.

In resource-shared DCC, upon receiving an incoming call, the server searches for the dialer call-inmatching the incoming number in the dialer call-incommands configured for the dialer interfaces on it.

Configuring ISDN caller identification callback in the circular DCC implementation

To configure ISDN caller identification callback client in the circular DCC implementation, perform the following configuration in dial interface (physical or dialer interface) view.

Table 761 Implement ISDN Caller Identification Callback (Client Configuration) in Circular

DCC

Operation

Command

 

 

Configure the destination addresses and

dialer route protocol

dial number(s) for calling one (or more)

next-hop-address dial-number

remote ends

 

 

 

To configure the ISDN caller identification callback server in the circular DCC implementation perform the following configuration in dial interface (physical or dialer interface) view.

Table 762 Implement ISDN Caller Identification Callback (Server Configuration) in Circular

DCC

Operation

Command

 

 

Configure the local end to implement

dialer call-in remote-number[

ISDN callback according to the ISDN caller

callback ]

identification

 

 

 

Disable the local end to implement ISDN

undo dialer call-in remote-number[

callback according to the ISDN caller

callback ]

identification

 

 

 

Configure the destination address(es) and

dialer route protocol

dial number(s) for calling one (or more)

next-hop-address dial-number

remote ends

 

 

 

By default, callback according to ISDN caller identification is not configured.

The dialer route command configured on the dial interface (physical or dialer) at the server should be exactly the same dialer route in the dial-in dialer number.

Configuring ISDN caller identification callback in the resource-shared DCC implementation

To configure ISDN caller identification callback client in the resource-shared DCC

implementation, perform the following configuration in dialer interface view.

Page 730
Image 730
3Com 10014299 Operation Command Configure the local end to implement, Identification, Undo dialer call-in remote-number