3Com 10014299 FRF.12, Fragment between them, III. Configuration Procedure 1 Configure Router a

Typical Frame Relay Configuration Example 279

II. Networking Diagram

Figure 95 networking diagram of Frame Relay over IP

Router A		Router B
S0	Frame Relay	S0
	Network

IP:202.38.163.251IP:202.38.163.252

III.Configuration Procedure 1 Configure Router A

[Router]interface serial 0

[Router-Serial0]ip address 202.38.163.251 255.255.255.0

[Router-Serial0]fr interface-type dte

[Router-Serial0]fr dlci 100

[Router-Serial0]fr map ip 202.38.163.252 dlci 100 compression frf9

2Configure Router B

You can configure Router B in the same way as that of Router A, so its configuration will not be mentioned here.

Typical Frame Relay	I. Networking Requirements
Fragment Example	RouterA and Router B connect with Frame Relay Network. and enable Frame Relay
(FRF.12)
	Fragment between them.

II. Networking Diagram

Figure 96 networking diagram of Frame Relay Fragment

S0	Frame Relay	S0
Router A		Router B

III.Configuration Procedure 1 Configure RouterA

[Router]interface serial0 [Router-Serial0]link-protocol fr

[Router-Serial0]ip address 10.1.1.2 255.0.0.0

[Router-Serial0] fr dlci 16 [Router-fr-dlci-16]fr-class frts

[Router]fr class frts

[Router-fr-class-frts]cir allow 64000

[Router-fr-class-frts]cbs 64000

[Router-fr-class-frts]cir 64000

[Router-fr-class-frts]fragment 80 data-level

2Configure RouterB

[Router]interface serial0 [Router-Serial0]link-protocol fr

[Router-Serial0]ip address 10.1.1.1 255.0.0.0

[Router-Serial0]fr dlci 16 [Router-fr-dlci-16]fr-class frts

[Router]fr class frts