3Com 10014299 Display and Debug IPX Display and Debug IPX, Configure Router a a Activate IPX

380 CHAPTER 24: CONFIGURING IPX

Display and Debug IPX Table 427 Display and Debug IPX

Operation	Command
Display interface status and interface	display ipx interface [ type number ]
parameters of IPX
Display IPX router information table	display ipx routing-table [ network
	static default ] [ verbose ]
Display IPX server information table	display ipx service-table [ type
	service-type name name network
	network socket socket order { net
	type } ] [ verbose ]
Display type and quantity of packets	display ipx statistics
received and transmitted
Clear IPX statistical information.	reset ipx statistics

Typical IPX Configuration Example

I. Networking Requirement

Networking with Router A and Router B. Here, both Server1 and Server2 are installed with NetWare 4.1. Server1 is the master server, its external network ID is 2, packet encapsulation format Arpa, and internal network ID 937f. Server2 is the slave server, its network ID is 3, packet encapsulation format is Snap, and internal network ID is 9300. The node of Ethernet interface of Router A is 00e0.fc01.0000, and its telephone number is 8810122. The node of Ethernet interface of Router B is 0.0c91.f61f, and its telephone number is 8810124.

II. Networking Diagram

Figure 137 Networking diagram of IPX configuration example

Router A 1000.e0.fc01.0 1000.0.0c91.f61f Router B

	Tel:	PSTN	Tel:	Modem
Modem
			8810124
2.e0.fc01.0	8810122			3.0.0c91.f61f
Hub				Hub

Sever1 Sever2

III. Configuration Procedure

1Configure Router A: a Activate IPX

[Router] ipx enable

bActivate IPX module on interface Ethernet0, the network ID being 2

[Router] interface ethernet 0

[Router-Ethernet0] ipx network 2

cSet encapsulation format of packets on Ethernet interface to Ethernet_II.

[Router-Ethernet0]ipx encapsulation ethernet-2

[Router-Ethernet0] exit