3Com 10014299 manual By default, the link idle time is 120 seconds, Configure the Link Idle Time

Configuring DCC 729

idle time, no the packet which complies with the “permit” statements are transmitted over the line.

Perform the following configuration in dial interface (physical or dialer interface) view.

Table 768 Configure the Link Idle Time

Operation	Command
Configure the link idle time	dialer timer idle seconds
Restore the link idle time to the default	undo dialer timer idle
value

By default, the link idle time is 120 seconds.

Configuring the link disconnection time before initiating the next call

After a line for DCC calls enters the down status due to faults or disconnection, a specified period of time must be elapsed (the interval before it can originate the next call) before a new dialup connection can be established again. Thereby, the possibility of overloading the remote PBX can be prevented.

Perform the following configuration in dial interface (physical or dialer interface) view.

Table 769 Configure the Link Disconnection Time Before Initiating the Next Call

Operation	Command
Configure the link disconnection time	dialer timer enable seconds
before initiating the next call
Restore the link disconnection time before	undo dialer timer enable
initiating the next call to the default value

By default, the link disconnection time is 20 seconds.

Configuring the link idle time when interface competion

If all the channels are unavailable when DCC originates a new call, a condition of contention occurs. Normally, after a line is set up, idle-timeout timer will take effect. However, if a call to a different destination address is originated at this time, competion will occur. In this case, DCC replaces the idle timeout timer with the compete-idle timer. In other words, the line will be automatically disconnected after the line-idle time exceeds the time specified by the compete-idle timer.

Perform the following configuration in dial interface (physical or dialer interface) view.

Table 770 Configure the Link Idle Time When Interface Competion

Operation	Command
Configure the link idle time when	dialer timer compete seconds
interface competion
Restore the link idle time when interface	undo dialer timer compete
competion to the default value

By default, the link idle time is 20 seconds when the interface competion occurs.